I am finally getting around to working on it again, and I would like to try to model a cockpit for it. Kit Building If you’re building a kit and have questions or want to discuss kit building post it here. No directions for mounting the wings (no holes drilled) and the rear of the wing does not sit into a notch. First, both wing panels had broken ribs.
I have the plans and was shocked to see that it is a one piece wing. Planning on running a fuji 64 in will post construction photos later in the build until then happy building ! Just started building 30% sd have been reading the 35% forums and they are very interesting. So the DA 50 cc will be going into this project and the price is right for this engine also Thanks, Dave I was thinking of building a 3o% + Swick Taylorcraft but the Decathlon seems tempting. However I think these would stillbe on the lower end of the power range.
Either should deliver more than adequate power with either a 10 x 6 or an 11 x 7 for better vertical if needed. There has got to be a way to conceal these even if we have to tape them the the underside of the wing all the way back between the hold down bolts. Yes, I anticipated that the aileron hookup would be unsightly. I did have a 40 size Zero that had a very fast glide unless I held in lots of up elevator to slow adrian casino it down.